Racing Stands *On Special this week*

Status
Not open for further replies.
Assez bonne qualité compte tenu du prix, c'est un excellent deal pour les 2. En arrière, ils utilisent des spools, donc sur les hondas, faut fabriquer de quoi pour utiliser ce stand, par contre, les autres marques (kawa, suz, yam) ont déjà les trous pour visser les spools...
 
Eric_Ok said:
pour ducati est-ce que ca marche??? kesse tu entend par spool??
tres merci beaucoup!:D
Click to expand...

les spool c'est les petite "bobinnes" que tu visse sur ton swingarm !
C'est la que le race stand s'appuie!

Je eput pas te dire, si tu as des trou avec des fillet pour mettre les spools
Vérifie!
Si oui il devrait etre pres de la bolt d'axle!
Sinon: tu devra modifier un peu le stand pour mettre des "palettes"(petit bras qui se place sous le swing arm directement)
 
Les Ducati n'ont pas le swingarm sur un côté de la roue ?
Ca t'en prends un spécial comme lui:
ducati.jpg
 
I have my spools and my stands (i've been screwed for the front one on e-bay, anyway...), I just want to make sure to do it right and not drope the bike ;)... When using the rear stand, I put the stand on the spool and lift it directly? Do you usually put your front wheel straight instead of the usual "locked" position?

Thnx,

Sylvain
 
CoOlSlY said:
I have my spools and my stands (i've been screwed for the front one on e-bay, anyway...), I just want to make sure to do it right and not drope the bike ;)... When using the rear stand, I put the stand on the spool and lift it directly? Do you usually put your front wheel straight instead of the usual "locked" position?

Thnx,

Sylvain
Click to expand...

Yes, front wheel straight. It's hard at the beginning to do it yourself, but you hold the bike straight by your left hand on the seat, and you slide the rear stand under the spools with your right hand (note: switch hands if you are a right/left hander). Once the rear stand is under the spools, the bike will stay straight, and it's just a matter of pushing down on the stand and voilà :D
 
I have these stands. The rear works well with my bike. Still havn't gotten the front to work properly yet, need to adust it.
 
those won't work for Honda cause Honda don't have place to bolt the spools on the swingarm! :(

Canadien Tire one are spools type and you need standard type!

if you know someone who can weld, you can modify them really easy though!
 
maxpat82 said:
those won't work for Honda cause Honda don't have place to bolt the spools on the swingarm! :(

Canadien Tire one are spools type and you need standard type!

if you know someone who can weld, you can modify them really easy though!
Click to expand...
true! just weld an M10 nut on each swing arm and you're good to go!
 
Status
Not open for further replies.
Back
Top