Drifting Techniques: Part 2

Status
Not open for further replies.

D1champ

New member
drift2.jpg


Feint Drift​

1. On approach to a turn, steer your vehicle away from the direction of the turn you wish to be made. The distance you begin to turn your vehicle away from the turn depends on how fast you are traveling. When you turn your vehicle away from the direction of the turn you want to make, you are loading up your suspension on one side of your vehicle, compressing the springs so that when you turn in the opposite direction, your vehicle will "bounce" back to its desired direction.

2. Once your suspension is compressed on the side of your vehicle opposite of the turn you wish to make, quickly turn back in the opposite direction. This feint motion should be done smoothly, but not necessarily quickly. Turning your wheels too quickly in opposite directions will cause your vehicle to understeer.

3. After rebounding your vehicle back into its desired direction, get on the throttle. When combined with the rotational force of the rebound, the excessive throttle will send your vehicle into a drift. FWD vehicles can use the E-Brake instead of the throttle to induce oversteer.

4. When you feel the vehicle’s rear end kicking out, immediately countersteer the wheels to face straight with the road. Your vehicle will pull in the direction of the front wheels, as long as the wheels are still moving. Keep on the throttle. If you press the brakes or let off the throttle because your vehicle is in an extremely oversteered condition, you will spin out or leave the road.

5. When you wish to straighten out your car, after completing the drift, let off the throttle smoothly and straighten out the wheels as your vehicle kicks in line behind the front tires.


Braking Drift​

1. Enter a turn at a speed too high for the vehicle to handle (if you do not drift, your vehicle should experience understeer at this speed).

2. Heel-Toe Downshift to get your vehicle into a gear low enough to cause the rear tires to break traction when you accelerate (2nd gear).

3. Turn your wheels sharply into the turn. By the time you finish downshifting and turning your wheels, you should be at the apex of the turn.

4. Accelerate hard, but balance the throttle to maintain the drift.

5. When you feel the vehicle’s rear end kicking out, immediately countersteer the wheels to face straight with the road. Your vehicle will pull in the direction of the front wheels, as long as the wheels are still moving. Keep on the throttle. If you press the brakes or let off the throttle because your vehicle is in an extremely oversteered condition, you will spin out or leave the road.

6. When you wish to straighten out your car, after completing the drift, let off the throttle smoothly and straighten out the wheels as your vehicle kicks in line behind the front tires.


Long Slide Drift

1. Enter a turn at high speed to perform this drift.

2. Turn your wheels into from the turn.

3. Hold in the release button on your E-Brake and pull up your brake sharply, then quickly release (e-brake is held up for only about 1 second). If using a RWD car, clutch in while pulling your E-Brake.

4. When you feel the vehicle’s rear end kicking out, immediately countersteer the wheels to face straight with the road. Your vehicle will pull in the direction of the front wheels, as long as the wheels are still moving. Keep on the throttle.

5. If your vehicle begins to lose speed while sliding sideways, heel-toe downshift into a gear low enough to pull your vehicle through the drift.

6. When you wish to straighten out your car, after completing the drift, let off the throttle smoothly and straighten out the wheels as your vehicle kicks in line behind the front tires.



Kansei Drift

1. Enter a turn at high speed. The Kansei Drift should be performed at race speeds. (if you do not drift, your vehicle should experience severe understeer at this speed).

2. Turn your wheels sharply into the turn, and let off the throttle quickly. The cornering force of the vehicle combined with the loss of throttle will cause your vehicle to oversteer.

3. When your vehicle begins to lose traction, get on the throttle again quickly. This will overpower the wheels for the traction that is available, sending your vehicle into a drift.

4. When you feel the vehicle’s rear end kicking out, immediately countersteer the wheels to face straight with the road. Your vehicle will pull in the direction of the front wheels, as long as the wheels are still moving. Keep on the throttle. If you press the brakes or let off the throttle because your vehicle is in an extremely oversteered condition, you will spin out or leave the road.

5. When you wish to straighten out your car, after completing the drift, let off the throttle smoothly and straighten out the wheels as your vehicle kicks in line behind the front tires.
 
FEINT DRIFT! :bigup:

Dans ltemps moi pis mes chums on appellait ca "l swigner en esti de cochon!! :D "......Mais maintenant c est plus raffiné. :laugh:
 
si vous iriez voir mon post ou tous l'information si haut a ete pris ! j'ai mis un liens vers : Drift Bible from the King, Keichi Tsuchiya

:)
 
c'est bin beau que tu sais faire du copier coller, mais sais-tu drifter vraiment pour vouloir donner des leçons ? :dunno:
 
//Grecko// said:
FEINT DRIFT! :bigup:

Dans ltemps moi pis mes chums on appellait ca "l swigner en esti de cochon!! :D "......Mais maintenant c est plus raffiné. :laugh:


hahaha!! :laugh:
 
Status
Not open for further replies.
Back
Top