recherche table inferieur avant+ball joint s14

Status
Not open for further replies.
civicvtec

civicvtec

New member
j'ai besoin d'un set de lower control arm avec le balljoint dessu pour un s14..fait moi signe si vous avez ca a vendre!!
 
menage du primptemps chepas ... trop presser de finir javais hate daller voir des jupes sur les terasse ...

non chepas je savais que javais sa, mais jlai trouve plus coliss.
 
dont know if i would thrust that Godspeed .... other after marcket arm goes for 450+ why is it so cheap !!!!!
 
rbs14 said:
dont know if i would thrust that Godspeed .... other after marcket arm goes for 450+ why is it so cheap !!!!!
Click to expand...

I know a site that only use that. They upgrade the bearings on the ends. Its made out of steel, not titanium or anything special. And usually spherical bearings are expensive. There is also the engineering cost to it. To create something costs a lot. Copying, well not much.

And PLZ SELL ME THE SUBFRAME ! :p
 
j'ai acheter la mienne chez nissan ... detail 260$ ... j'ai pas payé sa mais bon !!! c cher
 
Status
Not open for further replies.
Back
Top