Bcq de pieces a vendre tous presque neuf

Status
Not open for further replies.

LuckyDSM

Legacy Member
http://forums.montrealracing.com/showthread.php?t=79249


moteur.jpg

20g+tial.jpg

[[url]http://membres.lycos.fr/mctrx/intercooler.jpg/IMG][/url]
[IMG]http://membres.lycos.fr/mctrx/HeadStage3.jpg
BlockStage3.jpg



LuckyDSM@Hotmail.com
 
Last edited:
Wow, lots of nice stuff!!

Just some advice, theres a lot of low ballers on MR.com, you would save a lot of time if you posted prices for your parts...And you could reach a larger market if you also post them at www.dsmtrader.com, and the Canadian DSM board (www.ca.dsm.org) if you havent already.
The Canadian DSM board has a lot of Ontarians who spend a lot of money on their DSM's (but still go slower..haha), and you would probably find buyers there more easily.

Good Luck

:)
 
good idea, thx BlueDSM
BlueDSM said:
Wow, lots of nice stuff!!

Just some advice, theres a lot of low ballers on MR.com, you would save a lot of time if you posted prices for your parts...And you could reach a larger market if you also post them at www.dsmtrader.com, and the Canadian DSM board (www.ca.dsm.org) if you havent already.
The Canadian DSM board has a lot of Ontarians who spend a lot of money on their DSM's (but still go slower..haha), and you would probably find buyers there more easily.

Good Luck

:)
 
mise a jour:

Exhaust:
(1800km)
LuckyDSM&Camo Flapper door eliminator avec 3" Donwpipe ---vendu
Camo Exhaust 3" a grandeur
Muffleur Magnaflow street/race 3"
Exhaust Manifold 2G Ported&polish ---vendu


Fuel System:
(3000km)
Walbro 255lph HP Fuel pump ---vendu
Filtre a gaz k&n ---vendu
Aeromotive adjustable fuel pressure regulator ---vendu
Fuel gauge ---vendu
Rewired Fuel Pump
-6 an fuel complet line ---vendu



Intake:
(1800km)
MAF 2G
Intake Manifold Ported&polish match gasket (stage 3) ---vendu
Big Intercooler FMIC 34x8.5x3 2.5 in/out (Camo tuning) ---vendu
Bov Forge Max 40psi ---vendu
K&N Catch can ---vendu
Cold air intake avec Filtre K&N 9" ---vendu
Camo Elbow 2" 1/2 ---vendu


Motor:
(3000km)
Block 91 6 bolts Crower Stage 3 ---vendu
Clevite 777 Bearings oversize ---vendu
Polished Crank ---vendu
Arias Pistons 8.8:1 forgés, oversize de 0.020, ---vendu
ARP Cylinder Head Studs ---vendu
ARP Main Crankshaft Bolts ---vendu
ARP Connecting Rod Bolts ---vendu
Crower Big Rods ---vendu
Head Crower Stage 3 ---vendu
New head Gasket Cometic (800km) (tete 94)
Tete plané a 5 milliemes (800km) ---vendu
Crower Valves en Steinless oversize 1mm ---vendu
Crower Spring double/Retainer Kit Titanium .465" valve lift ---vendu
Tete 94 porté a son maximum, avec 5 angles de valves (camo tuning) ---vendu
Cams Crower stage 3 avec 408 de lift d'intake, 398 de lift d'exhaust et, 106 de lobs center ---vendu
Injecteurs Denso 720cc (1800km) ---vendu
TD06 20G Ported&clipped 25 degres (neuf 800km) ---vendu
Trial externe 40mm hp (1800km) ---vendu


Electronics:
(1800km)
Hallman boost controller ---vendu
Apexi S-AFC 2 Gen ---vendu
Autometer 30psi boost gauge ---vendu
Autometer fuel pression gauge, from rail ---vendu
EGT Aircraftspruce ---vendu


Interior:
(3000km)
Double pod gauge mount ---vendu


DriveTrain & Suspension:
(3000km)
ACT 2600lb Xtreme Clutch ---vendu
Front strut bars ---vendu
Apex pro kit springs drop 1.75"
Front pads Hawks hp +
Front, Bushing de Tab en Polurétane ---vendu


Miscellaneous:
Accel Thunder 300+ wires plugs ---vendu
205/r16/55 Avon zz3 (ca colle) (3000km)
 
Last edited:
Status
Not open for further replies.
Back
Top