BORA BOY
Legacy Member
So VAGCOM tells me that the O2 sensor, Heater, CAT is wacked and I have bad idle.
I have another DP with sensors installed (may be rusted in there) of a 2000 Golf but the front one is 5 wire while I have a 4 wire plug.
It has been imposible to get the old one off my downpipe; RED connector 4 wire.
I have two questions,
I had spliced another one on but it may be bad (came off a running car).
1) How can I look at the O2 operation in VAG-COM?
2) Can I wire the 4 pin connector to the 5 wire sensor; if so which one do I not connect?
Also what tool do I need to get the sensor out without killing it (I used a 22mm open wrench) should I heat it?
Thanks
I have another DP with sensors installed (may be rusted in there) of a 2000 Golf but the front one is 5 wire while I have a 4 wire plug.
It has been imposible to get the old one off my downpipe; RED connector 4 wire.
I have two questions,
I had spliced another one on but it may be bad (came off a running car).
1) How can I look at the O2 operation in VAG-COM?
2) Can I wire the 4 pin connector to the 5 wire sensor; if so which one do I not connect?
Also what tool do I need to get the sensor out without killing it (I used a 22mm open wrench) should I heat it?
Thanks