What did you do to your VW/Audi today?
- Thread starter MC SULY
- Start date
ScHyZo
Well-known member
Tu vas l'avoir demain lol stress pas.
Sent from my G3223 using Tapatalk
sotam123
Active member
finished up my wiring harness for the engine on friday, ran the grounds, power wires on saturday and got the car started on sunday..just had to crank it for about 10seconds for the fuel filter to fill up from the lift pump and it started right up!
still have a few odd sends to clean up and run the wires on the passenger side for the headlight and the hood sensor, then I need to pull the harness back out and tape it all shut with the Tesa tape.
plan on having the wiring 100% done by tuesday, then Ill start installing the axles,ic piping, make the charge pipe for the air filter, bolt the fenders, conenct the rad/a/c lines...hopefully all done by the end of the week.
I also need to get the tires dismounted on the OZs since i want to re-do the silicone bead on all 4 wheels.
still have a few odd sends to clean up and run the wires on the passenger side for the headlight and the hood sensor, then I need to pull the harness back out and tape it all shut with the Tesa tape.
plan on having the wiring 100% done by tuesday, then Ill start installing the axles,ic piping, make the charge pipe for the air filter, bolt the fenders, conenct the rad/a/c lines...hopefully all done by the end of the week.
I also need to get the tires dismounted on the OZs since i want to re-do the silicone bead on all 4 wheels.
mrdouble99
Legacy Member
J'ai brancher des affaires entre des affaires
sotam123
Active member
Got the engine wiring all done today and reinstalled for the last time!
Car has no codes and is good to go..
Now just need to reinstall the intercooler pipings, wire in the egt gauge,reinstall the interior, bleed clutch&brakes, add fluids, set ride height and test drive...lets see if i can get this done by the end of the week
Sent from my SM-G965W using Tapatalk
Car has no codes and is good to go..
Now just need to reinstall the intercooler pipings, wire in the egt gauge,reinstall the interior, bleed clutch&brakes, add fluids, set ride height and test drive...lets see if i can get this done by the end of the week
Sent from my SM-G965W using Tapatalk
AlpineWhiteDub
Well-known member
Piggy back?
mrdouble99
Legacy Member
sacrilège !
AlpineWhiteDub
Well-known member
oVeRdOsE
Well-known member
mrdouble99
Legacy Member
sotam123
Active member
Hahahahahaha i promise it was!makes no sens, are you sure the vag-com was plugged in?
New update..engine is done!
Still need to adjuster the new coilovers and install the dash...drove it around the block and i have 1 issue with the brakes....any help appreciated.
When the car is off the brakes are fine, when the car is turned on, there is a sort of "hissing/ pressure relief" sound that can be heard in the car when the pedal is pressed.
If I drive the car and press the brakes,they sorta feel soft at first, then the car seems to apply a lot more brake pressure on its own without me pressing the pedal more...if that makes sense..
When the car is off the brakes will get super hard as they should be...brakes are properly bleed.
Sent from my SM-G965W using Tapatalk
