Al_Scrap_Iron
Legacy Member
en plein sa jai trouvé jlai juste pas testé.
1.Raise the vehicle using a jack and support the specified points with a rigid rack.
2.Move the selector lever to "P" position, and turn on the power supply mode of the electric motor switch (but do not start the motor (Electric motor unit)).
3.Depress the brake pedal.
note Keep the brake pedal depressed until the power supply mode of the electric motor switch is turned off.
4.
caution
Do not operate the electric parking brake switch too quickly (wait for at least two seconds by the next switch operation). If yes, the ECU cannot recognise the switch operation. This may cause the indicator lamp or the warning lamp not to flash.
It is necessary to execute Step 5 and Step 6 within 7 seconds after executing Step 4 (brake warning lamp (red) and electric parking brake switch indicator lamp flashing).
Operate the electric parking brake switch and alternately apply and release the parking brake 10 times, and the brake warning lamp (red) and the electric parking brake switch indicator lamp will flash.
note The multi-information display should show "PARKING BRAKE TEMPORARILY NOT AVAILABLE".
5.Operate the electric parking brake switch once to release the parking brake.
6.Press the brake auto hold switch 10 time or more as soon as possible, then perform the release operation of the electric parking brake switch once.
7.After the system enters the maintenance mode, the electric parking brake warning lamp (yellow) will stay on (do not flash anymore).
note
The multi-information display should show "PARKING BRAKE SERVICE REQUIRED".
Once the system has entered the maintenance mode, the electric parking brake is released completely.
If you failed the operation of the switch and did not enter maintenance mode, repeat the procedure after 60 seconds have elapsed.
8.
caution
Do not operate the electric parking brake switch to apply the parking brake. If yes, the maintenance mode will be cancelled.
When the electric parking brake switch is pulled up even with the power supply mode of the electric motor switch OFF, the maintenance mode will be cancelled.
Release the brake pedal.
9.Turn off the power supply mode of the electric motor switch.
10.Disconnect the negative battery terminal of the auxiliary battery
C'est certain qu'au dealer y vont juste te dire sa prend leur machine magique, jme doutait ben qui a une procédure avec les switches
Seul conseil que je peux te donner est de laissé le caliper et les plaquette entre le disque pendant que tu fais tes test. Des fois selon les marque ca fais des move bizarre (genre sortir le caliper jusqu'a temps davoir une resistance meme quand tu veux seulement le mettre en brake service) et quand tu a pas de resistance bin... ca chie. Demande moi comme je sais....