what's your wastegate said on the logs? because I got the same problem on pump fuel, people are doing 12 while I'm doing 13 and when I look at my logs my wastegate is only at 35%
Any way to see if computer is pulling timing ?
What's your trap speed ?
Your ign timing look good , your wastegate at some point is only around 18-19% and I see that your still running the oem tmap instead of a n20 tmap
Well first of all with the regular tmap on map 2 your only boosting around 15-16psi so it's normal from what I see on your logs but if you put a n20 tmap and change the setting in your jb4 for this type you will boost 19psi on map 2. I see your boost safety is set 18psi , you should put it at 21 , what did you set on your duty bias?
Did you install a n20 tmap on your car or you just change the setting? Put a logs with the jb4
That doesn't show much.... install a n20 tmap on your car if you didn't do it yet , change the setting after in the jb4 to tell that you got a n20 tmap on and do a logs on a longer runs (floor it 1,2,3,4) shift around 6k rpm
your timing seem to be a bit high
Yes but i lowered the boost to 21 psi instead of 23 psi as suggested by terry. I'm still getting a lot of correction and boost appears to be all over the place.What are the number you put in your duty bias , did you put the one from the page that said for big turbo?