blackcivic11
New member
2004 Acura TSX
I have 0 pressure in the pedal and I can't get any to come back.
Everything worked fine before so a faulty clutch master cylinder or slave cylinder is very unlikely.
This is what I did:
1. Attached a rubber tube to the bleeding nipple on the slave cylinder.
2. Pushed the clutch pedal to the floor and held it there
3. Crack open the bleeder and let some fluid flow out
4. Close the bleeder
5. Release the clutch
Ever since the above procedure there is 0 pressure in the pedal. Tried vaccum bleeding but it just doesn't seem to want to come out completely I only get a little to come out.
Tried pressure bleeding with a home made pressure bleeder at 30PSI, again only a little comes out.
I'm at a complete loss right now no idea whats going on and makes no sense.
I want pressure back in my pedal PLEASE help me
I have 0 pressure in the pedal and I can't get any to come back.
Everything worked fine before so a faulty clutch master cylinder or slave cylinder is very unlikely.
This is what I did:
1. Attached a rubber tube to the bleeding nipple on the slave cylinder.
2. Pushed the clutch pedal to the floor and held it there
3. Crack open the bleeder and let some fluid flow out
4. Close the bleeder
5. Release the clutch
Ever since the above procedure there is 0 pressure in the pedal. Tried vaccum bleeding but it just doesn't seem to want to come out completely I only get a little to come out.
Tried pressure bleeding with a home made pressure bleeder at 30PSI, again only a little comes out.
I'm at a complete loss right now no idea whats going on and makes no sense.
I want pressure back in my pedal PLEASE help me